knot for skeevy

made this today because i ran out out MDF to make faces
and well ive been trying to motivate myself to make this knot b4 zeke is born
stopped making knots because every time i made them id do my back in as they are quite time consuming to cut out!!!!

blah

this one is small maybe 20x20cm
i was a little lazy with the desing (which is done by skeevy) and just cut out the printed image *shame on me* hence it is so small

i like the size - as i didnt think it would work so small - but i found the smallest drill bit that would fit both my jig blade and the knot soo yay.!!!

i could have dont the paint job better..
and up close there are quite a few 'obvious overcuts'
but it has worked well for its size
so yeah



**** skeevy - if you see this in the nxt 8hrs pls note me with an address and i should be able to have it sent by tomorrow (otherwise it wcould be awhile until i see a post office again..!)**********